Hub/Switch Reference Guide
585
Nortel WLAN—Security Switch 2300 Series Command Line Reference
System Log Commands
Use the system log commands to record information for monitoring and troubleshooting. WSS Software system logs are
based on RFC 3164, which defines the log protocol.
This chapter presents system log commands alphabetically. Use the following table to locate commands in this chapter
based on their use.
clear log
Clears the log messages stored in the log buffer, or removes the configuration for a syslog server and stops sending log
messages to that server.
Syntax
clear log [buffer | server ip-addr]
Defaults
None.
Access
Enabled.
Examples
To stop sending system logging messages to a server at 192.168.253.11, type the following
command:
WSS# clear log server 192.168.253.11
success: change accepted.
Type the following command to clear all messages from the log buffer:
WSS# clear log buffer
success: change accepted.
See Also
• clear log trace on page 559
System Logs set log on page 576
set log mark on page 578
show log buffer on page 579
show log config on page 581
show log trace on page 581
clear log on page 575
buffer Deletes the log messages stored in nonvolatile storage.
server ip-addr Deletes the configuration for and stops sending log messages to the
syslog server at this IP address. Specify an address in dotted decimal
notation.