Hub/Switch Reference Guide

582 Snoop Commands
NN47250-100 (Version 02.51)
ap: 3 Radio: 2
See Also
• clear snoop map on page 566
• set snoop map on page 568
• show snoop on page 570
show snoop stats
Displays statistics for enabled snoop filters.
Examples show snoop stats [filter-name [ap-num [radio {1 | 2}]]]
Defaults None.
Access Enabled.
History Introduced in WSS Software Version 4.0.
Usage The AP retains statistics for a snoop filter until the filter is changed or disabled. The AP then clears
the statistics.
Examples The following command shows statistics for snoop filter snoop1:
WSS# show snoop stats snoop1
Filter ap Radio Rx Match Tx Match Dropped Stop-After
===============================================================================
snoop1 3 1 96 4 0 stopped
filter-name Name of the snoop filter.
ap ap-num Number of a AP to which the snoop filter is mapped.
radio 1 Radio 1 of the AP.
radio 2 Radio 2 of the AP. (This option does not apply to single-radio models.)