Hub/Switch Reference Guide

Snoop Commands 581
Nortel WLAN—Security Switch 2300 Series Command Line Reference
show snoop info
Shows the configured snoop filters.
Syntax show snoop filter-name
Defaults None.
Access Enabled.
History Introduced in WSS Software Version 4.0.
Examples The following command shows the snoop filters configured in the examples above:
WSS# show snoop info
snoop1:
observer 10.10.30.2 snap-length 100
all packets
snoop2:
observer 10.10.30.3 snap-length 100
frame-type eq data
mac-pair (aa:bb:cc:dd:ee:ff, 11:22:33:44:55:66)
See Also
• clear snoop on page 565
• set snoop on page 567
show snoop map
Shows the AP radios that are mapped to a specific snoop filter.
Syntax show snoop map filter-name
Defaults None.
Access Enabled.
History Introduced in WSS Software Version 4.0.
Usage To display the mappings for all snoop filters, use the show snoop command.
Examples The following command shows the mapping for snoop filter snoop1:
WSS# show snoop map snoop1
filter 'snoop1' mapping
filter-name Name of the snoop filter.
filter-name Name of the snoop filter.