Hub/Switch Reference Guide

575
Nortel WLAN—Security Switch 2300 Series Command Line Reference
Snoop Commands
Use snoop commands to monitor wireless traffic, by using a AP as a sniffing device. The AP copies the sniffed 802.11
packets and sends the copies to an observer, which is typically a protocol analyzer such as Ethereal or Tethereal.
(For more information, including setup instructions for the monitoring station, see the “Remotely Monitoring Traffic”
section in the “Troubleshooting a WSS” chapter of the Nortel WLAN Security Switch 2300 Series Configuration Guide.)
This chapter presents snoop commands alphabetically. Use the following table to locate commands in this chapter based
on their use.
clear snoop
Deletes a snoop filter.
Syntax clear snoop filter-name
Defaults None.
Access Enabled.
History Introduced in WSS Software Version 4.0.
Examples The following command deletes snoop filter snoop1:
WSS# clear snoop snoop1
See Also
• set snoop on page 567
• show snoop info on page 571
Remote monitoring
(snooping)
set snoop on page 567
show snoop info on page 571
clear snoop on page 565
set snoop map on page 568
show snoop map on page 571
show snoop on page 570
clear snoop map on page 566
set snoop mode on page 569
show snoop stats on page 572
filter-name Name of the snoop filter.