Hub/Switch Reference Guide

Trace Commands 573
Nortel WLAN—Security Switch 2300 Series Command Line Reference
Defaults The default trace level is 5.
Access Enabled.
Examples The following command starts a trace for the 802.1X sessions for MAC address
00:01:02:03:04:05:
WSS# set trace dot1x mac-addr 00:01:02:03:04:05:
success: change accepted.
See Also
• clear trace on page 560
• show trace on page 564
set trace sm
Traces session manager activity.
Syntax set trace sm [mac-addr mac-address] [port port-num] [user username] [level
level]
Defaults The default trace level is 5.
Access Enabled.
Examples Type the following command to trace session manager activity for MAC address
00:01:02:03:04:05:
WSS# set trace sm mac-addr 00:01:02:03:04:05:
success: change accepted.
See Also
• clear trace on page 560
• show trace on page 564
mac-addr mac-address Traces a MAC address. Specify a MAC address, using colons
to separate the octets (for example, 00:11:22:aa:bb:cc).
port port-num Traces a port number. Specify a WSS port number between 1
and 22.
user username Traces a user. Specify a username of up to 80 alphanumeric
characters, with no spaces.
level level Determines the quantity of information included in the output.
You can set the level with an integer from 1 to 10, where level
10 provides the most information. Levels 1 through 5 provide
user-readable information. If you do not specify a level,
level 5 is the default.