Hub/Switch Reference Guide

Trace Commands 571
Nortel WLAN—Security Switch 2300 Series Command Line Reference
History Introduced in WSS Software Version 3.0.
Examples To save trace data into the file trace1 in the subdirectory traces, type the following
command:
WSS# save trace traces/trace1
set trace authentication
Traces authentication information.
Syntax set trace authentication [mac-addr mac-address] [port port-num] [user
username] [level level]
Defaults The default trace level is 5.
Access Enabled.
Examples The following command starts a trace for information about user jose’s authentication:
WSS# set trace authentication user jose
success: change accepted.
See Also
• clear trace on page 560
• show trace on page 564
set trace authorization
Traces authorization information.
mac-addr mac-address Traces a MAC address. Specify a MAC address, using colons
to separate the octets (for example, 00:11:22:aa:bb:cc).
port port-num Traces a port number. Specify a WSS port number between 1
and 22.
user username Traces a user. Specify a username of up to 32 alphanumeric
characters with no spaces.
level level Determines the quantity of information included in the output.
You can set the level with an integer from 1 to 10, where level
10 provides the most information. Levels 1 through 5 provide
user-readable information. If you do not specify a level, level 5
is the default.