Hub/Switch Reference Guide

570 Trace Commands
NN47250-100 (Version 02.51)
clear trace
Deletes running trace commands and ends trace processes.
Syntax clear trace {trace-area | all}
Defaults None.
Access Enabled.
Examples To clear all trace processes, type the following command:
WSS# clear trace all
success: clear trace all
To clear the session manager trace, type the following command:
WSS# clear trace sm
success: clear trace sm
See Also
• set trace authentication on page 561
• set trace authorization on page 561
• set trace dot1x on page 562
• set trace sm on page 563
• show trace on page 564
save trace
Saves the accumulated trace data for enabled traces to a file in the WSS’s nonvolatile storage.
Syntax save trace filename
Defaults None.
Access Enabled.
trace-area Ends a particular trace process. Specify one of the following keywords to end
the traces documented in this chapter:
• authorization—Ends an authorization trace
• dot1x—Ends an 802.1X trace
• authentication—Ends an authentication trace
• sm—Ends a session manager trace
all Ends all trace processes.
filename Name for the trace file. To save the file in a subdirectory, specify the
subdirectory name, then a slash. For example: traces/trace1