Hub/Switch Reference Guide

569
Nortel WLAN—Security Switch 2300 Series Command Line Reference
Trace Commands
Use trace commands to perform diagnostic routines. While WSS Software allows you to run many types of traces, this
chapter describes commands for those traces you are most likely to use. For a complete listing of the types of traces WSS
Software allows, type the set trace ? command.
This chapter presents trace commands alphabetically. Use the following table to locate commands in this chapter based
on their use.
clear log trace
Deletes the log messages stored in the trace buffer.
Syntax clear log trace
Defaults None.
Access Enabled.
Examples To delete the trace log, type the following command:
WSS# clear log trace
See Also
• set log on page 576
• show log buffer on page 579
Caution! Using the set trace command can have adverse effects on system
performance. Nortel recommends that you use the lowest levels possible for initial trace
commands, and slowly increase the levels to get the data you need.
Trace set trace sm on page 563
set trace dot1x on page 562
set trace authentication on page 561
set trace authorization on page 561
show trace on page 564
show trace on page 564
save trace on page 560
clear log trace on page 559