Hub/Switch Reference Guide

562 File Management Commands
NN47250-100 (Version 02.51)
See Also
• clear boot config on page 537
• reset system on page 546
• set boot configuration-file on page 550
• show version on page 554
Table 2: Output for show boot
Field Description
Configured boot version Software version the switch will run next time the software is
rebooted.
Configured boot image Boot partition and image filename WSS Software will use to
boot next time the software is rebooted.
Configured boot configuration Configuration filename WSS Software will use to boot next time
the software is rebooted.
Backup boot configuration The name of the configuration file to be used in the event that
WSS Software cannot read the configured boot configuration file
next time the software is rebooted.
Booted version Software version the switch is running.
Booted image Boot partition and image filename WSS Software used the last
time the software was rebooted. WSS Software is running this
software image.
Booted configuration Configuration filename WSS Software used to load the
configuration the last time the software was rebooted.