Hub/Switch Reference Guide

File Management Commands 561
Nortel WLAN—Security Switch 2300 Series Command Line Reference
History Introduced in WSS Software Version 1.1.
Usage To determine the boot partition that was used to load the currently running software image,
use the dir command.
Examples The following command sets the boot partition for the next software reload to partition
1:
WSS# set boot partition boot1
success: Boot partition set to boot1.
See Also
• copy on page 537
• dir on page 540
• reset system on page 546
show boot
Displays the system image and configuration filenames used after the last reboot and configured for use after
the next reboot.
Syntax show boot
Defaults None.
Access Access.
History
Examples
The following command shows the boot information for a WSS:
WSS# show boot
Configured boot version: 5.0.7.0.20
Configured boot image: boot1:N6050700.020
Configured boot configuration: file:configuration
Backup boot configuration: NONE
Booted version: 5.0.7.0.20
Booted image: boot1:N6050700.020
Booted configuration: file:configuration
Product model: 2360
Table 86 describes the fields in the show boot output.
Version 4.1
• New fields, Configured boot version and Backup
boot configuration, added