Hub/Switch Reference Guide

558 File Management Commands
NN47250-100 (Version 02.51)
If the configuration running on the switch is different from the one in the archive or you renamed the configu-
ration file, and you want to retain changes that were made after the archive was created, see the “Managing
System Files” chapter of the Nortel WLAN 2300 System Software Configuration Guide.
Examples The following command restores system-critical files on a switch, from archive
sysa_bak:
WSS# restore system tftp:/10.10.20.9/sysa_bak
success: received 11908 bytes in 0.150 seconds [ 79386 bytes/sec]
success: restore complete.
See Also backup on page 535
rmdir
Removes a subdirectory from nonvolatile storage.
Syntax rmdir [subdirname]
Defaults None.
Access Enabled.
History Introduced in WSS Software Version 3.0.
Usage WSS Software does not allow the subdirectory to be removed unless it is empty. Delete all
files from the subdirectory before attempting to remove it.
Examples The following example removes subdirectory corp2:
WSS# rmdir corp2
success: change accepted.
See Also
• dir on page 540
• mkdir on page 545
save config
Saves the running configuration to a configuration file.
subdirname Subdirectory name. Specify between 1 and 32 alphanumeric characters,
with no spaces.