Hub/Switch Reference Guide

556 File Management Commands

NN47250-100 (Version 02.51)

temporary files:

Filename Size Created

Total: 0 bytes used, 93537 Kbytes free

See Also

• dir on page 540

• rmdir on page 548

reset system

Restarts a WSS and reboots the software.

Syntax

reset system [force]

Defaults

None.

Access

Enabled.

Usage

If you do not use the force option, the command first compares the running configuration

to the configuration file. If the running configuration and configuration file do not match, WSS

Software does not restart the WSS but instead displays a message advising you to either save the

configuration changes or use the force option.

Examples

The following command restarts a WSS that does not have any unsaved configuration

changes:

WSS# reset system

This will reset the entire system. Are you sure (y/n)y

The following commands attempt to restart a WSS with a running configuration that has unsaved changes, and

then force the switch to restart:

WSS# reset system

error: Cannot reset, due to unsaved configuration changes. Use "reset system force" to

override.

WSS# reset system force

...... rebooting ......