Hub/Switch Reference Guide

File Management Commands 553
Nortel WLAN—Security Switch 2300 Series Command Line Reference
Syntax install soda agent agent-file agent-directory directory
Defaults None.
Access Enabled.
History Introduced in WSS Software Version 4.1.
Usage Use this command to install a .zip file containing SODA agent files into a directory on the WSS.
Prior to installing the SODA agent files, you must have already copied the .zip file to the WSS. This command
creates the specified directory, unzips the file and places the contents into the directory. If the specified
directory has the same name as an SSID, then that SSID uses the SODA agent files in the directory if SODA
functionality is enabled for the service profile that manages the SSID.
Examples The following command installs the contents of the file soda.ZIP into a directory called sp1.
WSS# install soda agent soda.ZIP agent-directory sp1
This command may take up to 20 seconds...
WSS#
See Also
• uninstall soda agent on page 556
• set service-profile soda mode on page 329
load config
Loads configuration commands from a file and replaces the WSS’s running configuration with the commands in the
loaded file.
Syntax load config [url]
agent-file Name of a .zip file on the WSS containing SODA agent files.
directory Directory on the WSS where SODA agent files are to be installed. The
command automatically creates this directory.
Caution! This command completely removes the running configuration and replaces it
with the configuration contained in the file. Nortel recommends that you save a copy of the
current running configuration to a backup configuration file before loading a new
configuration.
url Filename. Specify between 1 and 128 alphanumeric characters, with no
spaces.
If the file is in a subdirectory, specify the subdirectory name, followed by
a forward slash, in front of the filename. For example: backup_configs/
config_c.