Hub/Switch Reference Guide

542 RF Detection Commands
NN47250-100 (Version 02.51)
Syntax show rfdetect visible mac-addr
Syntax show rfdetect visible ap ap-num [radio {1 | 2}]
Syntax show rfdetect visible ap ap-num [radio {1 | 2}]
Defaults None.
Access Enabled.
History
Usage
If a Nortel radio is supporting more than one SSID, each of the corresponding BSSIDs is listed
separately.
To display rogue information for the entire Mobility Domain, use the show rfdetect mobility-domain command on the
seed switch.
Examples To following command displays information about the rogues detected by radio 1 on AP port 3:
WSS# show rfdetect visible ap 3 radio 1
Total number of entries: 104
Flags: i = infrastructure, a = ad-hoc
c = CCMP, t = TKIP, 1 = 104-bit WEP, 4 = 40-bit WEP, w = WEP(non-WPA)
Transmit MAC Vendor Type Ch RSSI Flags SSID
----------------- ------- ----- --- ---- ------ --------------------------------
00:07:50:d5:cc:91 Cisco intfr 6 -60 i----w r27-cisco1200-2
00:07:50:d5:dc:78 Cisco intfr 6 -82 i----w r116-cisco1200-2
00:09:b7:7b:8a:54 Cisco intfr 2 -54 i-----
00:0a:5e:4b:4a:c0 3Com intfr 11 -57 i----- public
00:0a:5e:4b:4a:c2 3Com intfr 11 -86 i-t1-- Nortelwlan
00:0a:5e:4b:4a:c4 3Com intfr 11 -85 ic---- nrtl-ccmp
00:0a:5e:4b:4a:c6 3Com intfr 11 -85 i-t--- nrtl-tkip
00:0a:5e:4b:4a:c8 3Com intfr 11 -83 i----w nrtl-voip
00:0a:5e:4b:4a:ca 3Com intfr 11 -85 i----- nrtl-webaaa
...
mac-addr Base MAC address of the Nortel radio.
Note: To display the base MAC address of a Nortel radio, use the
show ap status command.
ap-num Port connected to the AP for which to display neighboring BSSIDs.
ap-num Number of a AP for which to display neighboring BSSIDs.
radio 1 Shows neighbor information for radio 1.
radio 2 Shows neighbor information for radio 2. (This option does not apply to
single-radio models.)
Version 4.0 Vendor, Type, and Flags fields added.