Hub/Switch Reference Guide

RF Detection Commands 533
Nortel WLAN—Security Switch 2300 Series Command Line Reference
See Also set radio-profile countermeasures on page 287
show rfdetect counters
Displays statistics for rogue and Intrusion Detection System (IDS) activity detected by the APs managed by a WSS.
Syntax show rfdetect counters
Defaults None.
Access Enabled.
History Introduced in WSS Software 4.0.
Examples The following command shows counters for rogue activity detected by a WSS:
WSS# show rfdetect counters
Type Current Total
-------------------------------------------------- ------------ ------------
Rogue access points 0 0
Interfering access points 139 1116
Rogue 802.11 clients 0 0
Interfering 802.11 clients 4 347
802.11 adhoc clients 0 1
Unknown 802.11 clients 20 965
Interfering 802.11 clients seen
on wired network 0 0
Table 3: show rfdetect countermeasures Output
Field Description
Rogue MAC BSSID of the rogue.
Type Classification of the rogue device:
• rogue—Wireless device that is on the network but
is not supposed to be on the network.
• intfr—Wireless device that is not part of your
network and is not a rogue, but might be causing
RF interference with AP radios.
• known—Device that is a legitimate member of the
network.
Countermeasures Radio MAC MAC address of the Nortel radio sending countermeasures
against the rogue.
WSS-IPaddr System IP address of the WSS that is managing the AP that is
sending or will send countermeasures.
Port/Radio/Channel Port number, radio number, and channel number of the
countermeasures radio. For a AP, the connection number is
labeled ap. (This stands for ap.)