Hub/Switch Reference Guide
Port Commands 53
Nortel WLAN—Security Switch 2300 Series Command Line Reference
Defaults
All WSS ports are network ports by default.
Model AP-2330, AP-2330A, AP-2330B, and Series 2332 APs have two radios. On two-radio models, one radio is
always 802.11a. The other radio is 802.11b/g, but can be configured for 802.11b or 802.11g exclusively. If the country
of operation specified by the set system countrycode command does not allow 802.11g, the default is 802.11b.
Model AP-2330, AP-2330A, AP-2330B and Series 2332 APs have internal antennas but also have connectors for
optional use of external antennas. (Antenna support on a specific model is limited to the antennas certified for use with
that model.) To specify the antenna model, use the set {ap} radio antennatype command.
Access
Enabled.
History
Usage
You cannot set a port’s type if the port is a member of a port VLAN. To remove a port from a VLAN,
use the clear vlan command. To reset a port as a network port, use the clear port type command.
When you change port type, WSS Software applies default settings appropriate for the port type. Table 4 lists
the default settings that WSS Software applies when you set a port’s type to ap.
This command does not apply to any gigabit Ethernet ports or to ports 7 and 8 on the 2360/2361 switch and port 3 on the
2382.
Version 4.1 New values for model option added:
•2330
• 2330A
Version 5.0.11 New values for model option added:
• 2330B
Version 6.0 New values for model option added:
• 2332-A1, 2332-A2, 2332-A3, 2332-A4, 2332-
A5, 2332-A6, 2332-E1, 2332-E2, 2332-E3,
2332-E4, 2332-E5, 2332-E6, 2332-E7, 2332-E8,
2332-E9, and 2332-J1.
Table 4: AP Access Port Defaults
Port Parameter Setting
VLAN membership Removed from all VLANs. You cannot assign an AP
access port to a VLAN. WSS Software automatically
assigns AP access ports to VLANs based on user traffic.
Spanning Tree Protocol (STP) Not applicable
802.1X Uses authentication parameters configured for users.
Port groups Not applicable
IGMP snooping Enabled as users are authenticated and join VLANs.
Maximum user sessions Not applicable