Hub/Switch Reference Guide

52 Port Commands
NN47250-100 (Version 02.51)
Syntax set port type ap port-list
model {2330 | 2330A
| 2330B | 2332-A1 | 2332-A2 | 2332-A3 | 2332-A4 | 2332-A5 |
2332-A6 | 2332-E1 | 2332-E2 | 2332-E3 | 2332-E4 | 2332-E5 |2332-E6 | 2332-E7 |
2332-E8 | 2332-E9 | 2332-J1 }
poe {enable | disable}
[radiotype {11a | 11b| 11g}]
Note. Before configuring a port as an AP port, you must use the set system
countrycode command to set the IEEE 802.11 country-specific regulations on the WSS.
See set system countrycode on page 63.
Note. For Series 2332 access points, be sure the system country code is supported for
the selected access point model.
Note. For an AP that is indirectly connected to the WSS through an intermediate Layer 2
or Layer 3 network, use the set ap command to configure a AP.
Note. Before changing the port type from ap to wired-auth or from wired-auth to ap,
you must reset the port with the clear port type command.
port-list List of physical ports.
model {2330 | 2330A | 2330B | 2332-A1
| 2332-A2 | 2332-A3 | 2332-A4 |
2332-A5 | 2332-A6 | 2332-E1 | 2332-E2 |
2332-E3 | 2332-E4 | 2332-E5 |2332-E6 |
2332-E7 | 2332-E8 | 2332-E9 | 2332-J1 }
AP model.
poe enable | disable Power over Ethernet (PoE) state.
radiotype 11a | 11b | 11g Radio type:
• 11a—802.11a
• 11b—802.11b
• 11g—802.11g
Note: This option applies only to single-radio models.