Hub/Switch Reference Guide

802.1X Management Commands 509
Nortel WLAN—Security Switch 2300 Series Command Line Reference
See Also
• set dot1x timeout auth-server on page 505
• show dot1x on page 507
clear dot1x timeout supplicant
Resets to the default setting the number of seconds that must elapse before the WSS times out an authentica-
tion session with a supplicant (client).
Syntax clear dot1x timeout supplicant
Defaults The default for the authentication timeout sessions is 30 seconds.
Access Enabled.
History Introduced in WSS Software 1.0.
Examples Type the following command to reset the timeout period for an authentication session:
WSS# clear dot1x timeout supplicant
success: change accepted.
See Also
• set dot1x timeout supplicant on page 505
• show dot1x on page 507
clear dot1x tx-period
Resets to the default setting the number of seconds that must elapse before the WSS retransmits an EAP over
LAN (EAPoL) packet.
Syntax clear dot1x tx-period
Defaults The default is 5 seconds.
Access Enabled.
History Introduced in WSS Software 1.0.
Examples Type the following command to reset the EAPoL retransmission time:
WSS# clear dot1x tx-period
success: change accepted.
See Also
• set dot1x tx-period on page 506
• show dot1x on page 507