Hub/Switch Reference Guide

508 802.1X Management Commands
NN47250-100 (Version 02.51)
Access Enabled.
History Introduced in WSS Software 1.0.
Examples Type the following command to reset the maximum number of reauthorization attempts to the
default:
WSS# clear dot1x reauth-max
success: change accepted.
See Also
• set dot1x reauth-max on page 504
• show dot1x on page 507
clear dot1x reauth-period
Resets the time period that must elapse before a reauthentication attempt, to the default time period.
Syntax clear dot1x reauth-period
Defaults The default is 3600 seconds (1 hour).
Access Enabled.
History Introduced in WSS Software 1.0.
Examples Type the following command to reset the default reauthentication time period:
WSS# clear dot1x reauth-period
success: change accepted.
See Also
• set dot1x reauth-period on page 504
• show dot1x on page 507
clear dot1x timeout auth-server
Resets to the default setting the number of seconds that must elapse before the WSS times out a request to a RADIUS
server.
Syntax clear dot1x timeout auth-server
Defaults The default is 30 seconds.
Access Enabled.
History Introduced in WSS Software 1.0.
Examples To reset the default timeout for requests to an authentication server, type the following command:
WSS# clear dot1x timeout auth-server
success: change accepted.