Hub/Switch Reference Guide

802.1X Management Commands 507
Nortel WLAN—Security Switch 2300 Series Command Line Reference
clear dot1x port-control
Resets all wired authentication ports on the WSS to default 802.1X authentication.
Syntax clear dot1x port-control
Defaults By default, all wired authentication ports are set to auto and they process authentication requests
as determined by the set authentication dot1X command.
Access Enabled.
History Introduced in WSS Software 1.0.
Usage This command is overridden by the set dot1x authcontrol command. The clear dot1x port-control
command returns port control to the method configured. This command applies only to wired authentication
ports.
Examples Type the following command to reset the wired authentication port control:
WSS# clear dot1x port-control
success: change accepted.
See Also
• set dot1x port-control on page 502
• show dot1x on page 507
clear dot1x quiet-period
Resets the quiet period after a failed authentication to the default setting.
Syntax clear dot1x quiet-period
Defaults The default is 60 seconds.
Access Enabled.
History Introduced in WSS Software 1.0.
Examples Type the following command to reset the 802.1X quiet period to the default:
WSS# clear dot1x quiet-period
success: change accepted.
See Also
• set dot1x quiet-period on page 503
• show dot1x on page 507
clear dot1x reauth-max
Resets the maximum number of reauthorization attempts to the default setting.
Syntax clear dot1x reauth-max
Defaults The default is 2 attempts.