Hub/Switch Reference Guide

505
Nortel WLAN—Security Switch 2300 Series Command Line Reference
802.1X Management Commands
Use 802. IEEE X management commands to modify the default settings for IEEE 802.1X sessions on a WSS.
For best results, change the settings only if you are aware of a problem with the WSS’s 802.1X performance.
This chapter presents 802.1X commands alphabetically. Use the following table to locate commands in this
chapter based on their use. For information about configuring 802.1X commands for user authentication, see
Chapter , “AAA Commands,” on page 165.
Caution! 802.1X parameter settings are global for all SSIDs configured on the switch.
Wired Authentication Port
Control
set dot1x port-control on page 502
clear dot1x port-control on page 497
set dot1x authcontrol on page 500
Keys set dot1x key-tx on page 501
set dot1x tx-period on page 506
clear dot1x tx-period on page 499
set dot1x wep-rekey on page 506
set dot1x wep-rekey-period on page 507
Bonded Authentication clear dot1x bonded-period on page 496
set dot1x bonded-period on page 500
Reauthentication set dot1x reauth on page 503
set dot1x reauth-max on page 504
clear dot1x reauth-max on page 497
set dot1x reauth-period on page 504
clear dot1x reauth-period on page 498
Retransmission set dot1x max-req on page 501
clear dot1x max-req on page 496
Quiet Period and Timeouts set dot1x quiet-period on page 503
clear dot1x quiet-period on page 497
set dot1x timeout auth-server on page 505
clear dot1x timeout auth-server on page 498