Hub/Switch Reference Guide

494 RADIUS and Server Groups Commands
NN47250-100 (Version 02.51)
Defaults Global RADIUS parameters have the following default values:
• deadtime—0 (zero) minutes (The WSS does not designate unresponsive RADIUS servers as unavailable.)
• key—No key
• retransmit—3 (the total number of attempts, including the first attempt)
• timeout—5 seconds
Access Enabled.
History Introduced in WSS Software 1.0.
Usage To override the globally set values on a particular RADIUS server, use the set radius server
command.
Examples To reset all global RADIUS parameters to their factory defaults, type the following commands:
WSS# clear radius deadtime
success: change accepted.
WSS# clear radius key
success: change accepted.
WSS# clear radius retransmit
success: change accepted.
WSS# clear radius timeout
success: change accepted.
See Also
• set radius on page 487
• set radius server on page 490
• show aaa on page 210
clear radius client system-ip
Removes the WSS’s system IP address from use as the permanent source address in RADIUS client requests from the
switch to its RADIUS server(s).
Syntax clear radius client system-ip
Defaults None.
Access Enabled.
History Introduced in WSS Software 1.0.
Usage The clear radius client system-ip command causes the WSS to use the IP address of the interface
through which it sends a RADIUS client request as the source IP address. The WSS selects a source interface
address based on information in its routing table as the source address for RADIUS packets leaving the switch.
retransmit Number of transmission attempts made before declaring an unresponsive
RADIUS server unavailable.
timeout Number of seconds to wait for the RADIUS server to respond before
retransmitting.