Hub/Switch Reference Guide

493
Nortel WLAN—Security Switch 2300 Series Command Line Reference
RADIUS and Server Groups
Commands
Use RADIUS commands to set up communication between a WSS and groups of up to four RADIUS servers for remote
authentication, authorization, and accounting (AAA) of administrators and network users. This chapter presents
RADIUS commands alphabetically. Use the following table to locate commands in this chapter based on their uses.
(For information about RADIUS attributes, see the RADIUS appendix in the Nortel WLAN 2300 System Software
Configuration Guide.)
clear radius
Resets parameters that were globally configured for RADIUS servers to their default values.
Syntax clear radius {deadtime | key | retransmit | timeout}
RADIUS Client set radius client system-ip on page 488
clear radius client system-ip on page 484
RADIUS Servers set radius on page 487
set radius server on page 490
clear radius on page 483
clear radius server on page 486
Server Groups set server group on page 492
set server group load-balance on page 493
clear server group on page 486
RADIUS Proxy set radius proxy client on page 489
set radius proxy port on page 489
clear radius proxy client on page 485
clear radius proxy port on page 485
deadtime Number of minutes to wait after declaring an unresponsive RADIUS
server unavailable before retrying the RADIUS server.
key Password (shared secret key) used to authenticate to the RADIUS server.