Hub/Switch Reference Guide

459
Nortel WLAN—Security Switch 2300 Series Command Line Reference
Security ACL Commands
Use security ACL commands to configure and monitor security access control lists (ACLs). Security ACLs filter packets
to restrict or permit network usage by certain users or traffic types, and can assign to packets a class of service (CoS) to
define the priority of treatment for packet filtering.
(Security ACLs are different from the location policy on a WSS, which helps you locally control user access. For
location policy commands, see Chapter , “AAA Commands,” on page 165.)
This chapter presents security ACL commands alphabetically. Use the following table to locate commands in this
chapter based on their use.
clear security acl
Clears a specified security ACL, an access control entry (ACE), or all security ACLs, from the edit buffer. When used
with the command commit security acl, clears the ACE from the running configuration.
Syntax clear security acl {acl-name | all} [editbuffer-index]
Create Security ACLs set security acl on page 454
show security acl editbuffer on page 462
show security acl info on page 463
show security acl on page 461
clear security acl on page 449
Commit Security ACLs commit security acl on page 452
rollback security acl on page 453
Map Security ACLs set security acl map on page 459
show security acl map on page 464
clear security acl map on page 451
Monitor Security ACLs show security acl hits on page 462
set security acl hit-sample-rate on page 460
show security acl resource-usage on page 465
acl-name Name of an existing security ACL to clear. ACL names start with a
letter and are case-insensitive.
all Clears all security ACLs.
editbuffer-index Number that indicates which access control entry (ACE) in the
security ACL to clear. If you do not specify an ACE, all ACEs are
cleared from the ACL.