Hub/Switch Reference Guide

Port Commands 45

Nortel WLAN—Security Switch 2300 Series Command Line Reference

The following command removes AP 1:

WSS# clear ap 1

This will clear specified AP devices. Would you like to continue? (y/n) [n]y

See Also

• clear ap on page 24

• clear port type on page 27

• set port type ap on page 41

• set system countrycode on page 63

set port

Administratively disables or reenables a port.

Syntax

set port {enable | disable} port-list

Defaults

All ports are enabled.

Access

Enabled.

Usage

A port that is administratively disabled cannot send or receive packets. This command

does not affect the link state of the port.

Examples

The following command disables port 16:

WSS# set port disable 16

success: set "disable" on port 16

The fol1owing command reenables the port:

WSS# set port enable 16

success: set "enable" on port 16