Hub/Switch Reference Guide

IGMP Snooping Commands 441
Nortel WLAN—Security Switch 2300 Series Command Line Reference
See Also set igmp receiver on page 422
show igmp statistics
Displays IGMP statistics.
Syntax show igmp statistics [vlan vlan-id]
Defaults None.
Access All.
Examples The following command displays IGMP statistics for VLAN orange:
WSS# show igmp statistics vlan orange
IGMP statistics for vlan orange:
IGMP message type Received Transmitted Dropped
----------------- -------- ----------- -------
General-Queries 0 0 0
GS-Queries 0 0 0
Report V1 0 0 0
Report V2 5 1 4
Leave 0 0 0
Mrouter-Adv 0 0 0
Mrouter-Term 0 0 0
Mrouter-Sol 50 101 0
Table 4: Output for show igmp receiver-table
Field Description
VLAN VLAN that contains the multicast receiver ports. Ports are listed
separately for each VLAN.
Session IP address of the multicast group being received.
Port Physical port through which the WSS can reach the receiver.
Receiver-IP IP address of the receiver.
Receiver-MAC MAC address of the receiver.
TTL Number of seconds before this entry ages out if the WSS does
not receive a group membership message from the receiver. For
static multicast receiver entries, the TTL value is undef. Static
multicast receiver entries do not age out.
vlan
vlan-id
VLAN name or number. If you do not specify a VLAN, WSS Software
displays IGMP statistics for all VLANs.