Hub/Switch Reference Guide

IGMP Snooping Commands 433
Nortel WLAN—Security Switch 2300 Series Command Line Reference
Defaults The default robustness value for all VLANs is 2.
Access Enabled.
Examples The following example changes the robustness value on VLAN orange to 4:
WSS# set igmp rv 4 vlan orange
success: change accepted.
See Also
• set igmp oqi on page 418
• set igmp qi on page 420
• set igmp qri on page 420
show igmp
Displays IGMP configuration information and statistics for one VLAN or all VLANs.
Syntax show igmp [vlan vlan-id]
Defaults None.
Access All.
Examples The following command displays IGMP information for VLAN orange:
WSS# show igmp vlan orange
VLAN: orange
IGMP is enabled
Proxy reporting is on
Mrouter solicitation is on
Querier functionality is off
Configuration values: qi: 125 oqi: 300 qri: 100 lmqi: 10 rvalue: 2 Multicast
router information:
Port Mrouter-IPaddr Mrouter-MAC Type TTL
---- --------------- ------------------------ ------ -----
10 192.28.7.5 00:01:02:03:04:05 dvmrp 17
Group Port Receiver-IP Receiver-MAC TTL
--------------- ---- --------------- ----------------- --------- ------
224.0.0.2 none none none undef
237.255.255.255 5 10.10.10.11 00:02:04:06:08:0b 258
237.255.255.255 5 10.10.10.13 00:02:04:06:08:0d 258
237.255.255.255 5 10.10.10.14 00:02:04:06:08:0e 258
237.255.255.255 5 10.10.10.12 00:02:04:06:08:0c 258
237.255.255.255 5 10.10.10.10 00:02:04:06:08:0a 258
Querier information:
Querier for vlan orange
vlan vlan-id
VLAN name or number. If you do not specify a VLAN, WSS Software
displays IGMP information for all VLANs.