Hub/Switch Reference Guide

Port Commands 43
Nortel WLAN—Security Switch 2300 Series Command Line Reference
See Also set port on page 35
set ap
Configures a AP for an AP that is indirectly connected to the WSS through an intermediate Layer 2 or Layer 3
network.
Syntax set ap ap-num serial-id serial-ID
model {2330 | 2330A | 2330B | 2332-A1 | 2332-A2 | 2332-A3 | 2332-A4 | 2332-A5 |
2332-A6 | 2332-E1 | 2332-E2 | 2332-E3 | 2332-E4 | 2332-E5 |2332-E6 | 2332-E7 |
2332-E8 | 2332-E9 | 2332-J1 }
[radiotype {11a | 11b| 11g}]
Note. Before configuring an AP, you must use the set system countrycode command to
set the IEEE 802.11 country-specific regulations on the WSS. See set system countrycode
on page 63.
Note. For a complete listing of the models in the WLAN Series 2332 and their respective
countries of operation, please visit the Nortel Support website. http://www.nortel.com/support.
The Series 2332 access point has been region-locked to meet geographic regulatory
restrictions. Each model is associated to a specific regulatory domain and subsequent
country of operation. During installation, the access point model and wireless security switch
regulatory domain must match or the access point will not operate.
Note. For an AP that is directly connected to the WSS, use the set port type ap
command to configure an AP access port.
Note. The WLAN Series 2332 Access Points consist of the following models:
2332-A1, 2332-A2, 2332-A3, 2332-A4, 2332-A5, 2332-A6, 2332-E1, 2332-E2, 2332-E3,
2332-E4, 2332-E5, 2332-E6, 2332-E7, 2332-E8, 2332-E9, and 2332-J1.