Hub/Switch Reference Guide

425
Nortel WLAN—Security Switch 2300 Series Command Line Reference
IGMP Snooping Commands
Use Internet Group Management Protocol (IGMP) snooping commands to configure and manage multicast traffic
reduction on a WSS. This chapter presents IGMP snooping commands alphabetically. Use the following table to locate
commands in this chapter based on their use.
clear igmp statistics
Clears IGMP statistics counters on one VLAN or all VLANs on a WSS and resets them to 0.
Syntax clear igmp statistics [vlan vlan-id]
Defaults None.
Access Enabled.
IGMP Snooping State set igmp on page 416
show igmp on page 423
Proxy Reporting set igmp proxy-report on page 419
Pseudo-querier set igmp querier on page 421
show igmp querier on page 427
Timers set igmp qi on page 420
set igmp oqi on page 418
set igmp qri on page 420
set igmp lmqi on page 416
set igmp rv on page 422
Router Solicitation set igmp mrsol on page 417
set igmp mrsol mrsi on page 418
Multicast Routers set igmp mrouter on page 417
show igmp mrouter on page 426
Multicast Receivers set igmp receiver on page 422
show igmp receiver-table on page 429
Statistics show igmp statistics on page 431
clear igmp statistics on page 415
vlan
vlan-id
VLAN name or number. If you do not specify a VLAN, IGMP statistics
are cleared for all VLANs.