Hub/Switch Reference Guide

42 Port Commands
NN47250-100 (Version 02.51)
See Also show port counters on page 46
reset port
Resets a port by toggling its link state and Power over Ethernet (PoE) state.
Syntax reset port port-list
Defaults None.
Access Enabled.
Usage The reset command disables the port’s link and PoE (if applicable) for at least 1 second,
then reenables them. This behavior is useful for forcing an AP that is connected to two WSSs to
reboot over the link to the other switch.
Examples The following command resets port 5:
WSS# reset port 5
transmit-etherstats Tx 64 Number of packets transmitted that were 64 bytes
long.
Tx 127 Number of packets transmitted that were from 65
through 127 bytes long.
Tx 255 Number of packets transmitted that were from 128
through 255 bytes long.
Tx 511 Number of packets transmitted that were from 256
through 511 bytes long.
Tx 1023 Number of packets transmitted that were from 512
through 1023 bytes long.
Tx 1518 Number of packets transmitted that were from 1024
through 1518 bytes long.
port-list List of physical ports. WSS Software resets all the specified ports.
Table 3: Output for monitor port counters (continued)
Statistics Option Field Description