Hub/Switch Reference Guide

STP Commands 407
Nortel WLAN—Security Switch 2300 Series Command Line Reference
Defaults STP port fast convergence is disabled by default.
Access Enabled.
Usage Use port fast convergence on ports that are directly connected to servers, hosts, or other MAC
stations.
Examples The following command enables port fast convergence on ports 9, 11, and 13:
WSS# set spantree portfast port 9,11,13 enable
success: change accepted.
See Also show spantree portfast on page 405
set spantree portpri
Changes the STP priority of a network port or ports for selection as part of the path to the STP root bridge in the default
VLAN on a WSS.
Syntax set spantree portpri port-list priority value
Defaults The default STP priority for all network ports is 128.
Access Enabled.
Usage This command applies only to the default VLAN (VLAN 1). To change the priority of a port in
another VLAN, use the set spantree portvlanpri command.
Examples The following command sets the priority of ports 3 and 4 to 48:
WSS# set spantree portpri 3-4 priority 48
success: change accepted.
See Also
• clear spantree portpri on page 390
• clear spantree portvlanpri on page 391
• set spantree portvlanpri on page 398
• show spantree on page 400
set spantree portvlancost
Changes the cost of a network port or ports on paths to the STP root bridge for a specific VLAN on a WSS.
enable Enables port fast convergence.
disable Disables port fast convergence.
port-list List of ports. WSS Software changes the priority on the specified ports.
priority
value
Priority value. You can specify a value from 0 (highest priority) through
255 (lowest priority).