Hub/Switch Reference Guide

399
Nortel WLAN—Security Switch 2300 Series Command Line Reference
STP Commands
Use Spanning Tree Protocol (STP) commands to configure and manage spanning trees on the virtual LANs
(VLANs) configured on a WSS, to maintain a loop-free network. This chapter presents STP commands alpha-
betically. Use the following table to locate commands in this chapter based on their use.
STP State set spantree on page 393
show spantree on page 400
show spantree blockedports on page 404
Bridge Priority set spantree priority on page 399
Port Cost set spantree portcost on page 395
set spantree portvlancost on page 397
show spantree portvlancost on page 406
clear spantree portcost on page 390
clear spantree portvlancost on page 391
Port Priority set spantree portpri on page 397
set spantree portvlanpri on page 398
clear spantree portpri on page 390
clear spantree portvlanpri on page 391
Timers set spantree fwddelay on page 394
set spantree hello on page 394
set spantree maxage on page 395
Fast Convergence set spantree portfast on page 396
show spantree portfast on page 405
set spantree backbonefast on page 393
show spantree backbonefast on page 403
set spantree uplinkfast on page 399
show spantree uplinkfast on page 412
Statistics show spantree statistics on page 407
clear spantree statistics on page 392