Hub/Switch Reference Guide

AP Commands 385
Nortel WLAN—Security Switch 2300 Series Command Line Reference
See Also
• show ap connection on page 371
• show ap global on page 373
show load-balancing group
Displays an RF load balancing group’s member radios and current load for each radio.
Syntax show load-balancing group {group-name | all | [ap ap-number radio {1 | 2}]}
Defaults None.
Access Enabled.
History Introduced in WSS Version 6.0.
Usage Use this command to display information about the RF load-balancing groups configured on the
WSS and the individual AP radios in the load-balancing groups.
Table 21: Output for show ap unconfigured
Field Description
Serial Id Serial ID of the AP.
Model AP model number.
IP Address IP address of the AP. This is the address that the AP receives
from a DHCP server. The AP uses this address to send a Find
WSS message to request configuration information from WSS
switches. However, the AP cannot use the address to establish a
connection unless the AP first receives a configuration from a
WSS.
Port
Port number on which this WSS received the AP’s Find
WSS
message.
VLAN VLAN on which this WSS received the AP’s Find WSS
message.
group-name Name of an RF load-balancing group configured on the WSS switch.
all Displays information for every load-balancing group that has a radio on
this WSS switch as a member.
ap-number Index value that identifies the AP on the WSS switch.
radio {1 | 2} Shows status information for a radio on an AP. This option displays infor-
mation about radios in the same group as the specified radio.