Hub/Switch Reference Guide

384 AP Commands
NN47250-100 (Version 02.51)
See Also
• set ap on page 33
• set ap bias on page 249
• show ap config on page 344
• show ap connection on page 371
• show ap unconfigured on page 374
show ap unconfigured
Displays APs that are physically connected to the network but that are not configured on any WSSs.
Syntax show ap unconfigured
Defaults None.
Access Enabled.
Usage This command also displays an AP that is directly connected to a WSS, if the WSS port to which the
AP is connected is configured as a network port instead of an AP access port, and if the network port is a
member of a VLAN.
If a AP is configured on a WSS in another Mobility Domain, the AP can appear in the output until the AP is
able to establish a connection with a WSS in its Mobility Domain. After the AP establishes a connection, the
entry for the AP ages out and no longer appears in the command’s output.
Entries in the command output’s table age out after two minutes.
Examples The following command displays information for two APs that are not configured:
WSS# show ap unconfigured
Total number of entries: 2
Serial Id Model IP Address Port Vlan
----------- --------- --------------- ---- --------
0333001287 AP-241 10.3.8.54 5 default
0333001285 AP-252 10.3.8.57 7 vlan-eng
Table 54 describes the fields in this display.
WSS IP Address
System IP address of the WSS on which the AP is configured. A
separate row of output is displayed for each WSS on which the
AP is configured.
Bias Bias of the WSS for the AP:
•High
•Low
Table 20: Output for show ap global (continued)
Field Description