Hub/Switch Reference Guide

382 AP Commands
NN47250-100 (Version 02.51)
If a AP is configured on this WSS (or another WSS in the same Mobility Domain) but does not have an active
connection, the command does not display information for the AP. To show connection information for APs,
use the show ap global command on one of the switches where the APs are configured.
Examples The following command displays information for all APs configured on this WSS that have
active connections:
WSS# show ap connection
Total number of entries: 2
AP Serial Id AP IP Address WSS IP Address
--- ----------- --------------- --------------------------------
2 112233 10.10.2.27 10.3.8.111
4 0333000298 10.10.3.34 10.3.8.111
The following command displays connection information specifically for a AP with serial ID 223344:
WSS# show ap connection serial-id 223344
Total number of entries: 1
AP Serial Id AP IP Address WSS IP Address
--- ----------- --------------- ---------------------------
9 223344 10.10.4.88 10.9.9.11
Table 52 describes the fields in this display.
See Also
• show ap config on page 344
• show ap global on page 373
• show ap unconfigured on page 374
Table 19: Output for show ap connection
Field Description
AP Connection ID you assigned to the AP.
If the connection is configured on another WSS, this field
contains a hyphen ( - ).
Serial Id Serial ID of the AP.
AP IP Address IP address assigned by DHCP to the AP.
WSS IP Address
System IP address of the WSS on which the AP has an active
connection. This is the switch that the AP used for booting and
configuration and is using for data transfer.