Hub/Switch Reference Guide

380 AP Commands
NN47250-100 (Version 02.51)
show ap boot-configuration
Displays information about the static IP address configuration (if any) on a AP.
Syntax show ap boot-configuration ap-num
Defaults None.
Access Enabled.
History
Version 4.1 Command introduced in WSS Software.
Version 6.0 Option dap removed.
Field Mesh added
Field Mesh SSID added
Field Mesh PSK added
Examples The following command displays static IP configuration information for AP 1:
WSS# show ap boot-configuration 1
Flags: 0
AP: 1
IP Address: Disabled
VLAN Tag: Disabled
Switch: Disabled
Mesh: Disabled
IP Address:
Netmask:
Gateway:
VLAN Tag:
Switch IP:
Switch Name:
DNS IP:
Mesh SSID:
Mesh PSK:
Table 44 describes the fields in this display.
ap-num Index value that identifies the AP on WSS.
Table 18: Output for show ap boot-configuration
Field Description
AP AP number.
VLAN Tag The VLAN tag that the AP is configured to use (if any).