Hub/Switch Reference Guide

38 Port Commands

NN47250-100 (Version 02.51)

Examples

The following command clears port 5:

WSS# clear port type 5

This may disrupt currently authenticated users. Are you sure? (y/n) [n]y

success: change accepted.

See Also

• set port type ap on page 41

• set port type wired-auth on page 44

monitor port counters

Displays and continually updates port statistics.

Syntax

receive-etherstats | transmit-etherstats]

Defaults

All types of statistics are displayed for all ports. WSS Software refreshes the statistics every 5

seconds. This interval cannot be configured. Statistics types are displayed in the following order by default:

•Octets

•Packets

• Receive errors

• Transmit errors

• Collisions

• Receive Ethernet statistics

• Transmit Ethernet statistics

Access

All.

Usage

Each type of statistic is displayed separately. Press the Spacebar to cycle through the displays for

each type.

If you use an option to specify a statistic type, the display begins with that statistic type. You can use one statistic option

with the command.

Use the keys listed in Table 2 to control the monitor display.

octets Displays octet statistics first.

packets Displays packet statistics first.

receive-errors Displays errors in received packets first.

transmit-errors Displays errors in transmitted packets first.

collisions Displays collision statistics first.

receive-etherstats Displays Ethernet statistics for received packets first.

transmit-etherstats Displays Ethernet statistics for transmitted packets first.