Hub/Switch Reference Guide

378 AP Commands
NN47250-100 (Version 02.51)
See Also
• set ap radio auto-tune max-power on page 265
• set radio-profile auto-tune channel-config on page 279
• set radio-profile auto-tune channel-holddown on page 280
• set radio-profile auto-tune channel-interval on page 281
•
set radio-profile auto-tune power-backoff-timer on page 282
• set radio-profile auto-tune power-config on page 282
• set radio-profile auto-tune power-interval on page 283
• show auto-tune neighbors on page 368
• show radio-profile on page 376
show auto-tune neighbors
Displays the other Nortel radios and third-party 802.11 radios that a Nortel radio can hear.
Syntax show auto-tune neighbors
[ap ap-num [radio {1 | 2| all}]]
Defaults None.
Access Enabled.
History Introduced in WSS Software Version 3.0.
Option dap removed in version 6.0.
Packet Retransmission Count Number of retransmitted packets sent from the client to the radio
on the active channel. Retransmissions can indicate that the client
is not receiving ACKs from the AP radio.
Phy Errors Count Number of frames received by the AP radio that had physical
layer errors on the active channel. Phy errors can indicate
interference from a non-802.11 device.
ap-num AP port connected to the AP for which to display neighbors.
ap-num Number of a AP for which to display neighbors.
radio 1 Shows neighbor information for radio 1.
radio 2 Shows neighbor information for radio 2. (This option does not apply to
single-radio models.)
radio all Shows neighbor information for both radios.
Table 16: Output for show auto-tune attributes (continued)
Field Description