Hub/Switch Reference Guide

AP Commands 375
Nortel WLAN—Security Switch 2300 Series Command Line Reference
show ap vlan
Displays information about the VLANs that are either locally switched by the specified AP or tunneled from the AP to
an WSS switch.
bssid, ssid SSIDs configured on the radio and their BSSIDs.
RFID Reports Status of AeroScout asset tag support.
• Active—The AeroScout Engine has enabled the
tag report mode on the AP.
• Inactive—The AeroScout Engine has not
enabled, or has disabled, the tag report mode on
the AP.
Note: This field is displayed only if the rfid-mode option is
enabled on the radio profile that manages the radio.
Table 14: Output for show ap status terse and show ap status terse
Field Description
Port WSS port number connected to the AP.
Flg Operational status flags for the AP.
For flag definitions, see the key in the command output.
IP Address IP address of the AP. The address is assigned to the AP by a
DHCP server.
Note: This field is applicable only if the AP is configured on the
WSS as a AP.
Model AP model number.
MAC Address MAC address of the AP.
Radio1 State, channel, and power information for radio 1:
• The state can be D (disabled) or E (enabled).
• The channel and power settings are shown as
channel/power.
Radio2 State, channel, and power information for radio 2.
Uptime Amount of time since the AP booted using this link.
Table 13: Output for show ap status (continued)
Field Description