Hub/Switch Reference Guide

374 AP Commands
NN47250-100 (Version 02.51)
Radio 1 type
Radio 2 type
(cont.)
• Radar Detected indicates that DFS has detected
radar on the channel. When this occurs, the AP
stops transmitting on the channel for 30 minutes.
If RF Auto-Tuning is enabled for channel
assignment, the radio selects another channel and
performs the initial channel availability check on
the new channel, during which time the flag
changes back to Radar Scan.
Note: Radar Scan and Radar Detected apply only to 802.11a
radios, for country codes that use DFS.
• The following information appears for external
antennas:
• External antenna detected, configured as
antenna-model—Indicates that an external
antenna has been detected, and lists the
antenna model configured on the radio. (WSS
Software does not detect the specific model.)
• External antenna detected, not configured—
Indicates that an external antenna was detected
but no external antenna is configured on the
radio.
• External antenna not detected, configured as
antenna-model—Indicates that an external
antenna is configured on the radio but no
external antenna was detected.
operational channel The channel on which the radio is currently operating.
Note: If the channel number is followed by (Auto), the value was
set by RF Auto-Tuning.
operational power The power level at which the radio is currently operating.
Note: If the power setting is followed by (Auto), the value was
set by RF Auto-Tuning.
base mac Base MAC address of the radio.
Table 13: Output for show ap status (continued)
Field Description