Hub/Switch Reference Guide

Port Commands 37
Nortel WLAN—Security Switch 2300 Series Command Line Reference
clear port type
Removes all configuration settings from a port and resets the port as a network port.
Syntax clear port type port-list
Defaults The cleared port becomes a network port but is not placed in any VLANs.
Access Enabled.
Usage Use this command to change a port back to a network port. All configuration settings
specific to the port type are removed. For example, if you clear an AP port, all AP-specific settings
are removed. Table 1 lists the default network port settings that WSS Software applies when you
clear a port’s type.
Caution! When you clear a port, WSS Software ends user sessions that are using the
port.
port-list List of physical ports. WSS Software resets and removes the
configuration from all the specified ports.
Table 1: Network Port Defaults
Port Parameter Setting
VLAN membership None.
Note: Although the command changes a port to a
network port, the command does not place the port in any
VLAN. To use the port in a VLAN, you must add the port
to the VLAN.
Spanning Tree Protocol (STP) Based on the VLAN(s) you add the port to.
802.1X No authorization.
Port groups None.
Internet Group Management Protocol
(IGMP) snooping
Enabled as port is added to VLANs.
Access point and radio parameters Not applicable
Maximum user sessions Not applicable