Hub/Switch Reference Guide

AP Commands 369
Nortel WLAN—Security Switch 2300 Series Command Line Reference
Defaults None.
Access Enabled.
History
Examples
The following command displays the status of a AP:
WSS# show ap status 1
ap: 1, IP-addr: 10.2.30.5 (vlan 'vlan-corp'), AP model:2330,
manufacturer: Nortel, name: AP01
fingerprint: b4:f9:2a:52:37:58:f4:d0:10:75:43:2f:45:c9:52:c3
====================================================
State: operational (not encrypted)
CPU info: IBM:PPC speed=266666664 Hz version=405GPr
id=0x29c15335347f1919 ram=33554432
s/n=0333703027 hw_rev=A3
Uptime: 18 hours, 36 minutes, 27 seconds
radio 1 Shows status information for radio 1.
radio 2 Shows status information for radio 2. (This option does not apply to
single-radio models.)
Version 4.0
• New option added: terse
• New option added for show ap status: all
• New field added: fingerprint
• AP-WSS security status added to State field
Note: The fingerprint field and security state apply to the display
for APs only.
Version 4.1
• External antenna information added after the
radio state information, to indicate when an
antenna has been detected and to indicate the
configured antenna model number.
• Auto flag added to indicate operational channel or
power settings that are configured by RF Auto-
Tuning.
Version 5.0 Radar Scan and Radar Detected flags added to indicate when the
Dynamic Frequency Selection (DFS) feature is scanning for
radar or has stopped transmitting due to detected radar. The flags
apply to 802.11a radios only, and only for country codes where
DFS is used.
RFID Reports field added.
Version 6.0 Option dap removed.