Hub/Switch Reference Guide

368 AP Commands
NN47250-100 (Version 02.51)
TX: 307 44279
RX: 315 215046
Table 45 on page 358 describes the fields in the show ap mesh-links output.
Table 12: Output for show ap mesh-links
See Also
• set ap boot-configuration mesh ssid on page 254
• set service-profile mesh on page 320
show ap status
Displays AP and radio status information.
Syntax show ap status [terse] | [port-list | all [radio {1 | 2}]]
Field Description
AP Identifier for the AP on the WSS.
Name V-LAN name.
IP-addrs IP address of AP.
Operational Mode Indicates whether the AP is a Mesh AP or
Mesh Portal AP.
Downlink Mesh-APs Information about the Mesh APs that are
associated with the Mesh Portal AP.
BSSID Indicates the BSSID of the Mesh AP.
TX Indicates the amount of traffic (packets and
bytes) transmitted to the Mesh AP.
RX Indicates the amount of traffic (packets and
bytes) transmited to the Mesh AP.
terse Displays a brief line of essential status information for each AP.
port-list List of ports connected to the AP(s) for which to display status.
ap-num Number of a AP for which to display status.
all Shows status information for all directly attached APs and all APs
configured on the switch.