Hub/Switch Reference Guide

AP Commands 367
Nortel WLAN—Security Switch 2300 Series Command Line Reference
show ap group
Deprecated in WSS Software Version 6.0. To display information about RF load balancing, see show load-balancing
group
show ap mesh-links
Displays information about the links an AP has to Mesh APs and Mesh Portal APs.
Syntax show ap mesh-links ap-number
Defaults None.
Access All
History Introduced in WSS Software Version 6.0.
Examples The following command mesh link information for AP 7:
WSS# show ap mesh-links 7
AP: 7 IP-addr: 1.1.1.3
Operational Mode: Mesh-Portal
Downlink Mesh-APs
-------------------------------------------------
BSSID: 00:0b:0e:17:bb:3f (54 Mbps)
packets bytes
TxLateColl Number of frames that were not transmitted because they
encountered a collision outside the normal collision window.
TxMaxColl Number of frames that were not transmitted because they
encountered the maximum allowed number of collisions.
Typically, this occurs only during periods of heavy traffic on the
network.
TxMultiColl Number of transmitted frames that encountered more than one
collision.
TxUnderruns Number of frames that were not transmitted or retransmitted due
to temporary lack of hardware resources.
TxCarrierLoss Number of frames transmitted despite the detection of a
deassertion of CRS during the transmission.
TxDeferred Number of frames deferred before transmission due to activity on
the link.
ap-number Index value that identifies the AP on the WSS.
Table 11: Output for show ap etherstats (continued)
Field Description