Hub/Switch Reference Guide

AP Commands 363
Nortel WLAN—Security Switch 2300 Series Command Line Reference
show ap fdb
Displays the entries in a specified AP’s forwarding database.
Syntax show ap fdb ap-number
Defaults None.
Access All.
History Introduced in WSS Version 6.0.
Examples The following command displays FDB entries for AP 7:
WSS# show ap fdb 7
AP 7:
# = System Entry. $ = Authenticate Entry
VLAN TAG Dest MAC/Route Des [CoS] Destination Ports
---- ---- ----------------- ----- -----------------
4095 4095 00:0b:0e:00:ca:c1 # CPU
4095 0 00:0b:0e:00:04:0c eth0
Table 42 describes the fields in the show ap fdb output.
See Also
• set ap local-switching mode on page 260
• set vlan-profile
ap-number Index value that identifies the AP on the WSS switch.
Table 9: Output for show ap fdb
Field Description
VLAN VLAN number.
TAG VLAN tag value. If the interface is untagged, the TAG field is
blank.
Dest MAC/Route Des MAC address of this forwarding entry’s destination.
CoS Type of entry. The entry types are explained in the first row of the
command output.
Note. This Class of Service (CoS) value is not
associated with WSS quality of service (QoS) features.
Destination Ports WSS switch port associated with the entry. A switch sends traffic
to the destination MAC address through this port.