Hub/Switch Reference Guide

AP Commands 359
Nortel WLAN—Security Switch 2300 Series Command Line Reference
TKIP Pkt Replays 0 TKIP Decrypt Err 0
CCMP Pkt Decrypt Err 0 CCMP Pkt Replays 0
CCMP Pkt Transfer Ct 0 RadioResets 0
Radio Recv Phy Err Ct 0 Transmit Retries 60501
Radio Adjusted Tx Pwr 15 Noise Floor -93
802.3 Packet Tx Ct 0 802.3 Packet Rx Ct 0
No Receive Descriptor 0
TxUniPkt TxUniByte RxPkt UndcrptPkt TxMultiPkt TxMultiByte RxByte UndcrptByte PhyErr
1.0:1017 0 10170 0 14 8347 0 0 3964
2.0:5643 55683 822545 8697520 3 1670 0 0 8695
5.5:0 0 0 0 5 258 0 0 4
6.0: 0 0 0 0 0 0 0 51
9.0: 0 0 0 0 1 172 0 0 53
11.0: 0 0 0 0 17 998 0 0 35
12.0: 0 0 0 0 0 0 0 0 26
18.0: 0 0 0 0 0 0 0 0 38
24.0: 0 0 0 0 0 0 0 0 47
36.0: 0 0 0 0 0 0 0 0 1
48.0: 0 0 0 0 1 68 0 0 29
54.0: 0 0 0 0 0 0 0 0 5
TOTL: 6660 55683 832715 8697520 41 11513 0 0 0 12948
...
Table 41 describes the fields in this display.
Table 8: Output for show ap counters
Field Description
AP
Port
AP number.
WSS port number (if the AP is directly connected to the WSS
and the
WSS port is configured as an AP access port).
radio Radio number.
LastPktXferRate Data transmit rate, in Mbps, of the last packet received by the
AP.
NumCntInPwrSave Number of clients currently in power save mode.
LastPktRxSigStrength Signal strength, in dBm, of the last packet received by the AP.
LastPktSigNoiseRatio Signal-to-noise ratio (SNR), in decibels (dB), of the last packet
received by the AP.
This value indicates the strength of the radio signal above the
noise floor. For example, if the noise floor is -88 and the signal
strength is -68, the SNR is 20.
If the value is below 10, this indicates a weak signal and might
indicate a problem in the RF environment.
TKIP Pkt Transfer Ct Total number of TKIP packets sent and received by the radio.