Hub/Switch Reference Guide

356 AP Commands
NN47250-100 (Version 02.51)
Table 7: Output for show ap config
Field Description
Port WSS port number.
Note: This field is applicable only if the AP is directly connected
to the WSS and the WSS’s port is configured as an AP access
port.
AP Connection ID for the AP.
Note: This field is applicable only if the AP is configured on the
WSS as a AP.
serial-id Serial ID of the AP.
Note: This field is displayed only for APs.
AP model AP model number.
POE PoE state on the WSS port:
• Enable
• Disable
bias
Bias of the
WSS connection to the AP:
•High
•Low
name AP name.
fingerprint Hexadecimal fingerprint of the AP’s public encryption key.
Note: This field is displayed only for APs. If the field is blank,
the key has not been verified yet by an administrator. (See set ap
fingerprint on page 257.)
boot-download-enable State of the firmware upgrade option:
• YES (automatic upgrades are enabled)
• NO (automatic upgrades are disabled)
force-image-download State of the option to force the AP to o
load balancing group Names of the AP load-balancing groups to which the AP
belongs. If the value is None, the access point does not belong to
any load balancing groups.
Note: This field is displayed only if the AP is a member of a
group.
Radio Radio number. The information listed below this field applies
specifically to the radio.