Hub/Switch Reference Guide

AP Commands 355
Nortel WLAN—Security Switch 2300 Series Command Line Reference
Access Enabled.
History
Usage WSS Software lists information separately for each AP.
Examples The following example shows configuration information for an AP on WSS port 2:
WSS# show ap config 2
Port 2: AP model: 2330, POE: enable, bias: high, name: AP02
boot-download-enable: YES
force-image-download: NO
load balancing group: none
Radio 1: type: 802.11g, mode: disabled, channel: 6
tx pwr: 1, profile: default
auto-tune max-power: default
Radio 2: type: 802.11a, mode: disabled, channel: 36
tx pwr: 1, profile: default
auto-tune max-power: default
Examples The following example shows configuration information for a AP configured on
connection 1:
WSS# show ap config 1
Ap 1: serial-id: 12345678, AP model: 2330, bias: high, name: AP01
fingerprint: b4:f9:2a:52:37:58:f4:d0:10:75:43:2f:45:c9:52:c3
boot-download-enable: YES
force-image-download: NO
load balancing group: none
Radio 1: type: 802.11g, mode: disabled, channel: 6
tx pwr: 1, profile: default
auto-tune max-power: default
Radio 2: type: 802.11a, mode: disabled, channel: 36
tx pwr: 1, profile: default
auto-tune max-power: default
Table 40 describes the fields in this display.
Version 4.0
• New field added: fingerprint
Note: This field applies to the display for APs only.
Version 5.0
• Field force-image-download added:
• Field auto-tune min-client-rate removed.
• Field auto-tune max-retransmissions removed.
Version 6.0
• Option dap removed.