Hub/Switch Reference Guide

354 AP Commands
NN47250-100 (Version 02.51)
See Also
• set ap local-switching mode on page 260
• set vlan-profile
show ap config
Displays global and radio-specific settings for an AP.
Syntax show ap config [port-list [radio {1 | 2}]]
Defaults None.
Table 6: Output for show ap arp
Field Description
Host IP address, hostname, or alias.
HW Address MAC address mapped to the IP address, hostname, or alias.
VLAN VLAN the entry is for.
State Entry state:
• RESOLVING—WSS sent an ARP request for the entry and
is waiting for the reply.
• RESOLVED—Entry is resolved.
• EXPIRED—Entry is expired.
Type Entry type:
• DYNAMIC—Entry was learned from network traffic and
ages out if unused for longer than the ARP aging timeout.
• LOCAL—Entry for the WSS MAC address. Each VLAN
has one local entry for the switch MAC address.
• PERMANENT—Entry does not age out and remains in the
configuration even following a reboot.
• STATIC—Entry does not age out but is removed after a
reboot.
port-list List of ports connected to the AP(s) for which to display configuration
settings.
ap-num Number of a AP for which to display configuration settings.
radio 1 Shows configuration information for radio 1.
radio 2 Shows configuration information for radio 2. (This option does not apply
to single-radio models.)