Hub/Switch Reference Guide

AP Commands 353
Nortel WLAN—Security Switch 2300 Series Command Line Reference
Defaults The WPA IE is disabled by default.
Access Enabled.
History Introduced in WSS Software Version 3.0.
Usage When the WPA IE is enabled, the default authentication method is 802.1X. There is no default cipher
suite. You must enable the cipher suites you want the radios to support.
Examples The following command enables the WPA IE in service profile sp2:
WSS# set service-profile sp2 wpa-ie enable
success: change accepted.
See Also
• set service-profile auth-dot1x on page 307
• set service-profile auth-psk on page 309
• set service-profile cipher-ccmp on page 312
• set service-profile cipher-tkip on page 313
• set service-profile cipher-wep104 on page 314
• set service-profile cipher-wep40 on page 315
• show service-profile on page 380
show ap arp
Displays the ARP table for a specified AP.
Syntax show ap arp ap-number
Defaults None.
Access All.
History Introduced in WSS Version 6.0.
Examples The following command displays ARP entries for AP 7:
WSS# show ap arp 7
AP 7:
Host HW Address VLAN State Type
--------- ---------------------- ------------- -------------
10.5.4.51 00:0b:0e:00:04:0c 1 EXPIRED DYNAMIC
10.5.4.53 00:0b:0e:02:76:f7 1 RESOLVED LOCAL
Table 39 describes the fields in this display.
ap-number Index value that identifies the AP on the WSS switch.